[Openais] Re: strange behaviour with testamf3/4

Steven Dake sdake at mvista.com
Tue Jun 29 12:44:12 PDT 2004


Chris,

testamf3 and testamf4 are part of the same service unit.  This means
they will both go inservice/active or standby together.  If you now run
testamf1 and testamf2 (which are also a service unit), after this,
testamf1 and testamf2 will go in service and standby.  the testamf2
component is special in that it reports and cancels errors, so you will
see alot of state transitions for testamf1/testamf2 during its
operation.  Looking at the code should help understand if the states are
proceeding correctly.

The QUICKSTART instructions for using testamf* could use some beefing
up.

Thanks!
-steve

On Tue, 2004-06-29 at 12:34, Chris Friesen wrote:
> Just ran the testamf stuff, and am seeing issues:
> 
> Started executive.
> Started testamf3, got result of 1
> Started testamf4, got result of 1
> 
> Both instances went in service, then both went active.
> 
> The quickstart document says that one will be active, one standby--which is correct?
> 
> Chris
> 




More information about the Openais mailing list