[Bugme-new] [Bug 10581] New: via-rhine - no network after suspend to disk
bugme-daemon at bugzilla.kernel.org
bugme-daemon at bugzilla.kernel.org
Thu May 1 00:18:21 PDT 2008
http://bugzilla.kernel.org/show_bug.cgi?id=10581
Summary: via-rhine - no network after suspend to disk
Product: Drivers
Version: 2.5
KernelVersion: 2.6.24.3
Platform: All
OS/Version: Linux
Tree: Mainline
Status: NEW
Severity: normal
Priority: P1
Component: Network
AssignedTo: jgarzik at pobox.com
ReportedBy: tch at wpkg.org
I have a network card which uses via-rhine module. After I wake the machine up
after it was suspended to disk, network doesn't work.
dmesg tells this:
NETDEV WATCHDOG: eth0: transmit timed out
eth0: Transmit timed out, status ffff, PHY status ffff, resetting...
via-rhine: Reset not complete yet. Trying harder.
eth0: link up, 100Mbps, full-duplex, lpa 0xFFFF
NETDEV WATCHDOG: eth0: transmit timed out
eth0: Transmit timed out, status ffff, PHY status ffff, resetting...
via-rhine: Reset not complete yet. Trying harder.
eth0: link up, 100Mbps, full-duplex, lpa 0xFFFF
NETDEV WATCHDOG: eth0: transmit timed out
eth0: Transmit timed out, status ffff, PHY status ffff, resetting...
via-rhine: Reset not complete yet. Trying harder.
eth0: link up, 100Mbps, full-duplex, lpa 0xFFFF
NETDEV WATCHDOG: eth0: transmit timed out
eth0: Transmit timed out, status ffff, PHY status ffff, resetting...
via-rhine: Reset not complete yet. Trying harder.
eth0: link up, 100Mbps, full-duplex, lpa 0xFFFF
NETDEV WATCHDOG: eth0: transmit timed out
eth0: Transmit timed out, status ffff, PHY status ffff, resetting...
via-rhine: Reset not complete yet. Trying harder.
eth0: link up, 100Mbps, full-duplex, lpa 0xFFFF
The only thing which helps is unloading via_rhine module and loading it again -
after this, network works fine again.
00:12.0 Ethernet controller: VIA Technologies, Inc. VT6102 [Rhine-II] (rev 78)
Subsystem: ASRock Incorporation K7VT6 motherboard
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV+ VGASnoop- ParErr-
Stepping- SERR- FastB2B- DisINTx-
Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=medium >TAbort-
<TAbort- <MAbort- >SERR- <PERR- INTx-
Latency: 32 (750ns min, 2000ns max), Cache Line Size: 32 bytes
Interrupt: pin A routed to IRQ 18
Region 0: I/O ports at bc00 [size=256]
Region 1: Memory at dfffbc00 (32-bit, non-prefetchable) [size=256]
Capabilities: [40] Power Management version 2
Flags: PMEClk- DSI- D1+ D2+ AuxCurrent=0mA
PME(D0+,D1+,D2+,D3hot+,D3cold+)
Status: D0 PME-Enable- DSel=0 DScale=0 PME-
Kernel driver in use: via-rhine
Kernel modules: via-rhine
--
Configure bugmail: http://bugzilla.kernel.org/userprefs.cgi?tab=email
------- You are receiving this mail because: -------
You are on the CC list for the bug, or are watching someone who is.
More information about the Bugme-new
mailing list